Mathematical modelling of conjugate laminar and turbulent heat transfer in a cavity: Effect of a vertical glazed wall

abstract

© 2020 Elsevier Masson SASA numerical analysis of the laminar and turbulent natural convection combined with surface thermal radiation in a square cavity with a glazed wall is presented. The enclosure is composed of one left vertical isothermal wall, two horizontal adiabatic walls, and one right vertical partially semitransparent wall (clear glass sheet). Different values of the aspect ratio of the right vertical glazed wall (A=0.15,0.25,0.5,0.75,1.0) are analyzed, and the incoming solar irradiation (G) over the glass is varied from 0 to 750 W/m2 at intervals of 150 W/m2. Three different case studies were considered based on the position of the clear glass sheet on the right wall: (a) located at bottom side/Case 1 (C1), (b) located at the middle side/Case 2 (C2), and (c) located at the upper side/Case 3 (C3). The numerical solution was carried out using an in-house code based on the finite volume method. The numerical code was validated against experimental data for the turbulent natural convection problem. A comparison between the predicted and measured dimensionless vertical velocity, temperature profiles and local and average Nusselt numbers are presented, obtaining good agreement. Results show that convective heat transfer increases from about 70 to 250 as the aspect ratio increases from 0.15 to 1.0, for all solar radiation intensities, and all cases of turbulent flow. Also, radiative heat transfer decreases as the aspect ratio and solar radiation increase, which implies that it could become lower than convective heat transfer for some aspect ratio values set. When a laminar flow regime is considered, lower average convective and radiative heat transfer rates are obtained regarding the case of turbulent flow. In general, they are between 2.0